“My windbreak along the field had not been touched in years, and the limbs were crossing badly. He thinned it out, took the dead tops, and explained why he left the lower branches. The wind hits that row first, and it stands up much better now.”
“After the last blow, a big maple dropped a limb across my driveway. He came out, cut it up, chipped the brush, and checked the rest of the tree for splits. Told me straight that the tree was fine and did not need to come down.”
“He trimmed my cedar hedge back to a clean line and cleaned up every clipping. What I liked was that he told me not to cut it too hard on the old wood. Straight advice, no upselling.”
“A dead fir was leaning toward the roof, and he took it down in sections without touching the house. He showed me the rot at the base before he started. Fair price and a clean yard when he left.”
Stump Grinding in Kent, BC
A stump left in the lawn around Kent is more than an eyesore. It is a trip hazard for the kids, a blade breaker for the mower, and a slow invitation to insects and rot. I grind stumps below grade with a compact machine that fits through a standard gate, which matters on the older lots in town where the back yard sits behind a narrow side entrance. On soft winter ground I lay mats first, so I do not tear up your lawn dragging equipment to a stump at the far end of the property.
Kent and the Agassiz area keep me busy with farm windbreaks and the big trees in town, and both leave their share of stumps. Out on the windbreak lines the stumps sit in rows along the field edge, often western redcedar or Douglas-fir, and I grind the surface roots around each one so the mower passes clean. In town, the wind funnelling down the valley takes down trees and leaves a stump where a shade tree once stood. I work the roots out beyond the visible base, then either leave the chips to fill the hole or haul them away, whichever you prefer. If you plan to plant a new tree, lay sod or build in that same spot, tell me before I start and I will go deeper and clean the area more thoroughly.
Access is the part I check first. Some yards in Kent open easily from the driveway; others need the machine walked through a gate or down a slope, and that changes how I set up the day. I would rather look at the ground myself than guess over the phone, so call me at (236) 233-8128 and I will come out for a free estimate.
Tree Pruning in Kent, BC
In Kent, around Agassiz, the work I get called for most is pruning. This is farm country, and the windbreaks along the fields take a beating when the wind funnels down the valley. I walk those rows and look for the weak forks and the rubbing branches that will fail under wet snow or a winter gust. Out here a break in a windbreak is not cosmetic: it opens the field, and the next storm pushes further in. So I cut for the tree's health, not its looks, and I explain every cut before I make it.
The big trees in town need the same eye. I climb them myself and clear out deadwood, and I train young trees early so they grow a strong frame instead of becoming a future problem over a driveway or a roof. Since the 2021 heat dome I watch how a tree handles a dry summer: a stressed tree gets lighter cuts and more care, never a heavy prune in the heat. For most deciduous trees, late fall through late winter is my preferred window, when the sap is down and the wounds close cleanly.
Access shapes the job in Kent. I size my equipment to the gate, the laneway and the space between the barn and the fence line, and I chip the brush as I go. If you have a windbreak, a shade tree or a young tree you want trained right, call me at (236) 233-8128 for a free estimate.
Tree Cabling and Bracing in Kent, BC
In Kent, around Agassiz, most of my cabling work comes down to two kinds of trees: the tall cottonwoods and big-leaf maples standing along the farm windbreaks, and the mature shade trees in town that catch the wind as it funnels down the valley. Those windbreaks take a beating year after year, and sooner or later a fork goes weak or a limb splits. When the tree is otherwise healthy, that is exactly the moment cabling earns its keep. I climb it myself, check the union and the wood around it, and if the structure is sound I install flexible cables high in the crown so the limbs share the load in wind and wet snow. Where a split has already opened, I add steel bracing rods to hold it.
What I look for on the ground here matters as much as what I see from the top. Farm windbreaks are often crowded, with old damage buried inside the row, and some of the in-town trees sit close to fences, sheds and driveways, so I plan the climb and the rigging around the access I actually have. Cabling supports a tree; it does not fix rot. If my inspection shows the wood is too far gone, I will tell you straight and we will talk about removal instead of selling you a brace that will not hold.
I check my installations over time, because a cable is only as good as the union it protects, and a tree that was fine last spring can change after a wet winter. If you have a tree in Kent with a weak fork or a split limb, call me at (236) 233-8128 and I will come out for a free estimate.
Emerald Ash Borer Protection in Kent, BC
In Kent, around Agassiz, I look after farm windbreaks and the big trees in town, which take strong winds funnelling down the valley. That is exactly the setting where an ash can sit unnoticed until the damage is already done. Emerald ash borer was first detected in British Columbia in 2024, in the Lower Mainland, and once it moves into a tree it kills it within a few years. On the windbreak rows and the older yard trees here, an ash that starts to fail is not just one tree lost: it opens the row to the wind that comes down the valley every winter.
When I come out, I check the crown, the bark and the trunk for early signs. I look for thinning at the top, D-shaped exit holes in the bark, and splits running up the trunk. Those are the clues that tell me whether the tree is still worth protecting. From there I give you a straight answer on what makes the most sense: protective injections, regular monitoring, or removal. I will also explain why ash wood and firewood should not be moved around, since that is how this insect travels from one property to the next. On farm rows and in town yards alike, the access is usually tight, so I plan the work around gates, fences and the space my truck and chipper can actually reach.
If you have an ash in the yard, now is the time to look at it, before there is damage to repair. Call me at (236) 233-8128 for a free estimate, and I will tell you honestly what I see.
Brush Chipping Service in Kent, BC
When I pull into Kent with my chipper, it is usually because a pile of branches has gotten out of hand. Around Agassiz, that pile often comes from farm windbreaks: long rows of trees that take the wind as it funnels down the valley, and that drop limbs every time a storm rolls through. Add a weekend of yard work or a big pruning job on the big trees in town, and the debris adds up fast. Instead of dragging it all to the curb, I bring the machine to your property and turn the whole pile into mulch in one visit.
The chipper takes clean wood: branches, limbs, brush, and the tops I cut off during pruning. It does not take stones, wire, lumber, or anything with metal in it, so I ask you to keep those out of the pile before I arrive. On farm properties, that means checking the windbreak rows for old fence wire and posts. In town, it is usually rocks from a garden bed or scraps from a weekend project. Tell me roughly how big the pile is when you call, and I can plan the visit and give you a free estimate.
You can keep the chips for your garden beds, paths, or around your trees, where they hold moisture through our dry summers, or I can haul them away. Either way, storm-damaged limbs get dealt with on site, without a trailer full of branches sitting at the curb for weeks. If you are in Kent and the pile is getting ahead of you, call me at (236) 233-8128 for a free estimate.
Kent, as the arborist sees it
In Kent, around Agassiz, my work splits into two clear halves: farm windbreaks and the big trees in town. The valley funnels strong winds straight down through here, and you can read that in the trees. Along the field edges, the windbreaks take the brunt of it, and a row that has not been pruned in years turns into a tangle of crossed limbs and weak leaders. When I walk those lines, I look for the trees that are rubbing, the ones with included bark, and the tops that have already started to lean from windthrow. In town, the big shade trees are the other half of the job. These are mature trees with wide crowns, and they need proper pruning to keep weight off the ends of the limbs before the next blow. By Agassiz Speedway and around the community centre, I see plenty of older trees that have been left to grow into the wires and the rooflines. I do not top them, and I tell people why: a topped tree throws weak shoots that break in the next wind. What I do is thin the crown, remove the deadwood, and cable the co-dominant stems that are starting to split. In spring, I am usually clearing storm damage and chipping brush; in summer, I am on hedges and windbreak lines; in fall, I am removing the trees that have finally died back. If you are near the Agassiz Fall Fair grounds, you know how much wind comes across those open fields. The service entrance wire from the pole to your house is the only hydro line I work around, and I keep my distance from it. For anything on the municipal side, the service d'urbanisme de Kent can tell you what paperwork applies before a removal.